Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The bug description says when a 'renew' request is sent this bug takes effect. Is that correct? I have a device which shows all the symptoms apart from the fact that it never got any IP addresses using DHCP, so there were no 'renewals'.
Does 16.6.5 release for C9300-48UXM support smart licensing?
According to this document https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-9/release_notes/ol-16-9-9300.html#id_79702 the smart licensing is supported fr...
The configuration is fine, the session at the destination switch is fine and up but at the source switches it is down.
CoreSwitch01.SC.US# sh monitor session 1session 1---------------type : erspan-sourcestate : down (Unsupported route (e.g. tunnel, ...
The backup configuration file shows only one syslog server.
# WLC Config Begin <Wed Jul 5 05:32:50 2017>
config logging syslog host <removed_ip>config wlan apgroup interface-mapping add Office 5 management
Show tech shows two, and we actually have ...
Prime Infrastructure 3.1 Unable to login. The error message is
"could not open hibernate session for transaction".
We tried ncs restart, did not help. We are little skeptical about trying ncs cleanup. Can anybody help please? It's urgent.
Opened a Cisco TAC case, they said this: ++ Licenses will be managed as smart licenses from Cisco IOS XE Fuji 16.9.1 and later. Right-To-Use Licenses will be deprecated from Cisco IOS XE Fuji 16.9.1.
Here is the output that you requested:
az84cpi01/admin# show application status NCS
Health Monitor is running, with an error. ( [Role] Primary [State] HA not Configured )initHealthMonitor(): can not start DBDatabase server is stoppedFTP Service is r...
