Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
infuriating, I recall seeing a thread on this but cannot recall the detail. I would like to display the full DID number on the top line of the phone <area code + number > yet have only the extension number < last five digits of DID > appear on the ...
I currently have an on-net 4 digit dial plan deployed in a dispersed TDM environment which is fully utilised. I am transitioning to a unified solution and have determined a five digit plan is the way forward. I have a range of new numbers direct into...
I have a fuzzy notion it is possible to dial a predefined number from your phone and hear a recorded audio file. I want to offer an audio feed to some video "howto's" i have created. I don't have Unity. I think it might be possible to link a DN to ...
The number of devices registered on the cluster is far greater than the content of directory.asp file. Can someone advise how i refresh directory.asp to show all my registered phones? Thanks
first thought was whether the switch was in a stack - are all the ports set with the same properties? for range to work all the ports have to have the same base config. might trigger a thought from another. watching.
discovered my own answer.i revereted to base config then re applied step-by-step.i resolved the issue by not connecting the two switches until both were fully configured and had rebooted. then connecting each 10G cable in sequence the config brought ...
hi Guys,I too have a similar question. Just received a pair of 4500X 16Ten G out-of-the-box switches. I have configured verbatim the example in the linkhttps://supportforums.cisco.com/document/124626/virtual-switching-system-vss-configuration-cisco-4...
