Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Typically the topology for our sites has been a redundant pair of routers, then a redundant set of Layer 3 switches, however many access switches are needed, and then the end devices.
However, it has been suggested that we transition to an "all-in-on...
I would like to know if it's possible to configure two factor authentication for Cisco AnyConnect on a Cisco Router.
I have found the following guide for configurating AnyConnect on a router here:
http://www.cisco.com/c/en/us/support/docs/routers/38...
I have an existing Call Handler configured for a department in my company. The head of that department would like to create a temporary greeting message for the holidays that, when a number is dialed from the original call tree (3 in this case), the...
Pictured above is a very simple representation of the network as it stands today. We have recently added the VPLS Mesh via charter to connect our remote sites, and allow them to pass tagged traffic across, with the goal of segmenting each site into...
Is it possible to create a DN in Call MAnager that would allow you to broadcast a message to multiple phones, making them go off-hook and have the message broadcast out their speakers. The idea being emergency message broadcasts throughout an office...
ip multicast-routing was enabled on all L3 devices between the server and the end user. Over the VPLS Charter mesh, the two L3 devices use a SVI to connect to each other. Between the two core switches is simply a L3 link. PIM DM was enabled on all ...
The default gateway for all VLAN's at the remote site are on the top switch at that site. From there, routes are distributed throughout the network via OSPF, and the CORE SWITCH_1 device propagates a default route down through the devices via OSPF. ...
Ok, that answers one important question that I had, but it raises another: Where, other than the Gateway configuration mode, and the DN's that we've talked about, is the configuration for these? Does a user dial the DN's, and it sends that traffic o...
