Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone.. i have been looking through multiple posts on the forum for similar cases but have not found the answer Im looking for.. I've been primarily using this thread for guidance. https://community.cisco.com/t5/networking-knowledge-base/settin...
ASR1002-RP1IOS version: asr1000rp1-adventerprisek9.03.16.08.S.155-3.S8-ext.bin
Hi everyone..
Just wondering if anyone else has experienced an issue with a ASR1002 crashing and rebooting upon application of a ipsec profile onto a tunnel.
Seem to co...
Hi guys..
We are running a 3850 switch stack on version 03.03.05SE
While running the "show wireless ap summary" command on our stack I noticed an unusually high number of clients connected per AP..
LQ-SW-3850STK-1#sh wireless ap summary Sub-Domain A...
Hi guys, I was hoping someone would be able to advise on a Calling Number display output we are seeing on our office phones ..
We have a SIP trunk set up between our CUCM 7.1.5 office environment into a seperate studio phone system ( Phonebox 4 ).
Th...
Hi guys, We are running DX80s on our CUCM 10 infrastructure..We have SIP route patterns created in CUCM which route to our VCS environment, which then get passed out as appropiate.These route patterns are all domain name entriesI am now looking to cr...
Thanks for the reply.. I tried this and still no joy.. due to time constraints, I am gonna put the ISP router into Bridge Mode, however I gonna lab this up and try again another time..
Thanks for the reply Manu
Interesting.. which software version are you currently running as the Advanced Enterprise images I have tried have all crashed..
Regards
Jon
Thanks for the reply @lespejel
I've just given this a go ( using physical interface as source ) and the router still immediately crashes/reboots as soon as I apply the profile into the tunnel as suggested. ( dont even get as far as applying the "tunn...
Hey everyone..Just thought Id say that we've figured this out.. There was a setting in the CUCM SIP trunk which is not covered in the VCS-CUCM integration pdf document..See screen shot.. as soon as I changed the setting, my URI started getting passed...
