Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to use switch-to-switch MACSEC encryption between two Catalyst 9300s that are connected to different leaf switches, at different sites, of an Cisco ACI multipod setup? The MACSEC ports on either end would be connected to the same EPG i...
Does anyone know the IPSec throughput of the ASR 920 12SZ-IM model? I can't find the figure in any documentation.
http://www.cisco.com/c/en/us/products/collateral/routers/asr-920-series-aggregation-services-router/datasheet-c78-733397.html
http://www...
Any ideas why an Nexus 7K would be choosing an OSPF external route over an Interarea route?
The N7K has two OSPF routing processes and is getting the route via each process (this is expected). It seems to be choosing the path with the lowest cost fi...
I have two brand new Cisco 920-12SZ-IM routers. They have a single power supply installed in each of them.
After booting up both routers have the STAT LED showing solid red. The fan tray light is green. The PWR LED is green. The documentation shows ...
Do the Cisco 3850 series switches support MACSEC encryption on 10Gb SFP+ switch to switch or switch to router links? Is any additional cards, modules or hardware required?
I am looking at running MACSEC on some point-to-point links between 3850s and...
There is a critical alarm generated for each interface that is up but does not have a physical connection. This alarm can be turned off my putting these ports in an admin down state.
There is also a critical alarm for not having a second power supply...
Thanks for the response. Our external database if Radius but I think we can get it to send back a Radius attribute string that we can use to map the ACLs to.
