Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllPlease have a look at the attached diagram to see my issue.Basically, I need to connect multiple clients on the same network behind a switch that doesnt support PVLANs but still secure them from communicating with each other.My thought was to c...
Hi ThereI have a (hopefully) simple problem which may be more PC related rather than IP Communicator related.Basically, I want to be able to pick and choose which audio device to use for the different Audio types.eg:- use my USB headset for Headset m...
Hi AllHere's my setup: ---VLAN200---server1r1---VLAN100---l3sw1---VLAN200---server2 ---VLAN200---server3l3sw1 has vlan interfaces configured for VLAN100 and VLAN200 and is routing between the two.Each server is o...
Hi AllAll of my config archives are failing with error:"CM0020: Error creating archive"Im also getting a lot of:"Couldnot copy file contents from 20080408091310812-10.134.47.146.cfg to 11-20080408091307.cfg."A bit of history:I recently changed the ho...
Hi AllI wonder if someone can help me with a NAT problem. It's seems to be a relatively simple setup, but I cant get it to work properly.Ive set up a simple lab as follows:laptop1<-->fe0/1-router-fe0/0<-->laptop2laptop1-eth1 = 1.1.1.100laptop1-eth1:...
Hi PeterThanks for the reply.Did you see the diagram? Im not sure how much more information I can give, but will give it a go:I need client's 1 and 2 to be isolated from each other but the switch that they connect to does not support PVLANs (switchp...
I just realized that this command ("switchport protected") is not supported on my 4948.I do have "switchport port-security", but it doesnt look like that's what I want. It seems to be used for locking down based on MAC address."switchport protected" ...
No, I cant do that. This particular setup is very restrictive. I dont have any flexibility to change the VLAN.But I think it's ok. Im pretty sure the switchport protected will be enough.Thanks everyone for the help.
