Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to get a Cisco SPA232D to register with my CUCM 10.5 system without any success. I have created a new phone security profile that has digest authentication enabled along with a SIP profile that was copied from the Standard SIP profile. I ...
I have a new installation of UCCX 8.0.2 SU3 HA and twice now it has been reported that in the morning agents are unable to login to CAD, the error they receive is "Initialization Failed. Please try again or try restarting the application." The only t...
I have a 7961G-GE SCCP phone that was reset to factory defaults by holding the # button down while the lightswent from headset, mute and speaker. After which 123456789*0# was pressed. The phone switched to upgrading and I can see it trying to grab te...
I have a new UCON 7.1.2 server that is intgrated with AD for users and authentication. I was able to import all of my users without any issues and when I setup an IMAP account for testing I used a non-domain user with a local UCON password. This work...
My registration issues were because of my SPA232D settings. I have attached my settings to this reply. The DECT to base registration is covered in the SPA manual. Just go to settings on the handset and then handset registration, then register. Press ...
This is what I used. In my case I did not want to use the FXS port on the Base unit so Line 1 was disabled. In CUCM the device shows registered to the MAC address of the Base and the SPA302D has the DN/Ext and is working as expected.
Carlo, That did the trick! Thank you for your help. I have Line 1 registered with my CUCM server. If I want to register a DECT Line 1 to CUCM will that need to be added as a separate SIP device with another end user associated with that l...
The end user has been associated with the extension number. I'm pretty sure that CUCM is setup correctly, what I am lacking are the settings on the SPA232D that need to be configured.thanks, Steve
I am trying to get one of these units registered to CUCM. Can you take a couple of screen shots of the SPA232D configuration for me? I am still seeing the device as "rejected" in CUCM and when looking at the CUCM traces it appears that the SPA232D is...
