Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a VG350 with a defective power supply.sho environmentSYSTEM POWER SUPPLY STATUS==========================Internal Power Supply 1 Type: ACInternal Power Supply 1 Input Status and 12V Output Status: FailInternal Power Supply 2 Type: ACInternal P...
I have a 6509E with 4000 Watt power supplies that is currently in power redundancy mode = redundant.
I am getting PWRDENY on module 7 which is a 6716-10GE module needing 488.46 W and there is only 441.0 W available.
This module has been running witho...
I need to create a port channel between an existing 2960X stack of say 4 2960X-FPD-L's and a single 2960X-24PD-L. I am looking for some examples that are not a single switch to a single switch, or cross stack to a cross stack .
We had a Sup 2T throw a parity error, TAC RMA'd a replacement SUP2T. I ensured that the same IOS version was on the replacement. Inserted the card and in Show Mod it shows pass and ok however when I look at the show redundancy I am seeing the replace...
I have two 2960 Stacks Stack # 1 is a PoE stack with two WS-C2960S-48FPD-L with TenGig uplinks running c2960s-universalk9-mz.152-1.E.bin.Stack #2 is Non PoE stack with three WS-C2960S-48TS-L running c2960s-universalk9-mz.150-2.SE2.bin.I need to add a...
I should have been more clear. It is my understanding that it is best to use LACP when configuring cross-stack port channels. but PaGP when creating a port channel between two single switches or between a single switch and a stack. Is that correct?
I have been unsuccessful thus far. I will continue to read and peck away at getting multiple commands i.e. configuration and enable commands to work together in the same cli template.
MarvinUsing the basic cli template and a single command to a single switch worked. However I need to run a couple of commands to multiple switches like;1) system mtu jumbo 90002) copy running-config startup-config3) reload ThanksMike
Here is the output from these two commands show license allLicense Store: Primary License StorageLicense Store: Evaluation License StorageStoreIndex: 0 Feature: TEST_FEATURE_1 Version: 1.0 License Type: Evaluation L...
Leo So I will create etherchannels between my two stacks They will l be configured as stated above. Is it a good design to have the etherchannels terminate on the access switches switch 1 and switch 3 ?Quiting caffeine is a tough one. I have done it ...
