Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My CUCM lab server running 11.5.1.12900-21 on UCS c240 chassis had an expired tomcat and tomcat-trust certificate.
I rotated the expired certificates as part of the process Restarted tomcat service and the cisco TFTP service as suggested
but the prom...
I have a 10.5 CUCM cluster .
I see that some of completed calls from Mobile phones to internal numbers do not seem to appear in the CDR records at all.
But on the other hand I made similar calls to other internal extensions which seemed to be seen i...
I am presently in a CUCM 10.5 cluster . My CDR - QOS related fields like latency, jitter, packet loss are all seen as null.. I went to the system > scheduler >CDR load and unchecked the Load CDR only check box and saved yet I dont see the values loa...
Iam a newbie to the expressways.recently while reading through about Expressway setups.I saw a picture which had Expressway- C (In the inside of the Firewall)Expressway- E (In the DMZ)The expressway C then runs a SIP trunk to the CUCM.As I understa...
I have had a recent CUCM upgrade and had move to 10.5 version from 7.1. we have some staffs who have a primary line and a shared line.when the staff is on a their primary line in a call, and when some one rings their shared line.In order to pick up t...
Hi Jaime
Under Control center- Network services
i can see the CDR agent running on all servers
in the pub i can see CDR agent, Respository manager. CAR scheduler , CAR DB & SOAP - call record services running
Control Center feature services
for pu...
Hi Manish,
Thanks for the response
Yes i checked the Call Diagnostics enabled flag is set as 'Enabled regardless of CDR enabled Flag' . so i would assume it is enabled making no difference here.
Regards,
Arun
Thanks a lot rob, it worked wonders. I also found one more thing , this issue is seen with phones holding more than 2 lines . ( phones with two lines it still works without having to enable it)I turned the Auto Line select Enabled and it worked on p...
