Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Having problems with ATA 190 SC becoming unresponsive. This is happening on the Webex calling devices at multiple sites whether connect to a fax, analog phone or phone interface of paging system. Any ideas? Cycling the power restores them. They s...
Can the UCCX Quality Manager program support multiple UCCX systems? This is not about supporting an HA pair put completely separate UCCX systems each of which are configured as highly available. If not, where can I find supporting documentation?
I am looking for the procedure to upgrade a UCCX-Enhanced HA cluster to UCCX-Premium HA. I know the SKU's to order the upgrades. Is there an upgrade procedure or is it a fresh install with DRS restore? I will likely do a fresh install with restore...
In cucm 8.6(2), when I see the state of a phone as unknown that used to be registered to the CUCM but has been disconnected, how long from the time of disconnect until the phone shows as unknown? Is there a timer or is it a reboot of a system, etc? ...
Did you configure the device for 8 calls instead of the default 2? This is on the line configuration for the user. Go to each user, Call, line (primary) and set the simultaneous calls.Terry AbbottSr. Collaboration Solutions Architect | SMPTAbbott@s...
