Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
I'm using a IR829GW as a terminal server, this has two Async ports, one of them using rolled cable (rj45-rj45) to connect to the console port in 1841 router. When I telnet y notice the terminal server is establishing the reverse telnet sess...
Hello Guys
I'm trying to establish a L3VPN service over GRE. I have IOS and IOS XR routers at the ends in which I've configured the customer VRF interfaces. As I see the IOS interface configuration command "tunnel vrf"to define the VRF on which the...
Hi Guys I have a situation. The scenario (see the attached diagram) has to PE01 (IOS) connecting via a port-channel to P01 (IOS-XR), turn P01 connect to PE02 (IOS-XR). So we've configured a pseudowire between PE01 and PE02, this works fine! then we'v...
Hi GuysI would appreciate a lot your experiences and best practices about operating and monitoring dual stack networks in Service Provider environments. Currently we're working in a 6VPE model for Internet customers in order to provide dual stack ser...
Hello GuysI wanna to implement PE redundancy for CE devices on the access layer. We have l3vpn customers, VRFs are terminated on PE routers, so all the traffic going to CE devices is layer 2, except for some CE devices that are working in layer 3. So...
Hello
Are you sure you have your both PCs connected on the right ports on the switch? and do they have its right gateway configured, check it just in case.
Please take an output from your ports configuration
show run int f0/1
show run int f0/2
sho...
Hi Kasper
I don't know what happens with the link, look at the bellow link, page 79 shows CPI 2.x part numbers:
http://www.cisco.com/c/dam/en/us/products/collateral/cloud-systems-management/prime-infrastructure/presentation-c97-735996.pdf
First you...
Hi Kasper
In the previous versions to 2.x you needed to buy both Prime LMS and WCS to manage wired and wireless devices, but with CPI 2.x and later you don't need to buy licensing to manage Wireless devices separately anymore.
Now you have migrated ...
Thanks Sam, please let me to know how should I interpret the Major (Lo) threshold? the router shows 4230 as Low for Major.
R/S/I Modules Sensor Minor Major Critical
...
