Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I am just playing around in GNS3 trying to set up multiple ECMP links between to P routers like this;CE1 -- PE1 -- P1 == P2 -- PE2 -- CE2(There are actually four links between P1 & P2!)I have set up a pseudoswire xconnect from PE1 to PE2 so CE1 & ...
Is there anyway I can see how many routes are internal to an AS?So, something like "show ip route in AS1234" where AS1234 is the local AS number. All internal routes within AS1234 are being parsed around via iBGP, but AS1234 has a full BGP table from...
Is there anyway I can see the power usage on either a 3550 switch and/or 7301 router? I have some far away I wish to see the usage off.Devices with module power supplies like cat 4500s/6500s/7600 etc all have commands like "show power ...", which wil...
Searching the Internet with Google I can find many sellers of fibre patch leads but none of them state factors about their fibres in their spec sheets like the refractive index of their fibres or the V number, or NAs. If they were all different you w...
The following is a snippet from "show version" after a device lost power;sw1 uptime is 3 hours, 22 minutesSystem returned to ROM by power-onSystem restarted at 13:16:51 BST Wed Nov 21 2012Initially when this switch started up it was logging errors in...
If you guys didn't see my notes above, PPPoE server is not officially supported for the ASR920 (even though it mostly works). Only PPPoE as a client and PPPoE IA.
Multilink PPP was not working for me. I opened a TAC case and they have confirmed that MLPPP is not supported on the ASR920. In the IOS-XE release notes for the ASR920 it states that PPPoE is support (but this is supposed to mean as a client not serv...
OK, so I was being an idiot and the ASR hadn't booted 3.16.4aS. but 3.16.0 image, after rebooting to 3.16.4aS this works fine for PPPoE sessions. I am aiming for Multilink PPP though and that isn't working.
