Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to use a copy and paste method of getting to all of my network devices to get a view of the network. I will then build a visio from that (don't get me started on all the tools for that specifically). I want to be able to login and then pa...
I have been working on getting FXS attached devices to be able to make calls (mostly faxing) from a remote site thru our corporate PRI. I have setup the GW in CUCM as H.323 and given it a CSS of "PSTNGateway_CSS" which contains my Internal_PT, VM_Pil...
Just ran across this, and it was VERY annoying. I had to install ram to take my system from 2GB to 6GB to support CUPS 8.6.4. However, when I installed the ram it made my server think it was a 7828 and would give an error that the hardware was not su...
I just completed my PUT order for the upgrade license from 7.x to 8.x and the only options I was able to see were for the UNRESTRICTED version of the software. I waited for my order to be fulfilled and eDelivery to happen and sure enough, I got a PAK...
I came across the following when upgrading an offline server from 7.1.5 to 8.6.2. I was using an MCS 7835-h2 server for a staged upgrade and took a backup of 7.1.5. Then performed a restore to a lab server then upgraded to 8.6.2. Then I took a backup...
Is there a way to set this up as a phone service similar to extension mobility? Not everyone will have enough buttons for a speed dial of the DN, but a phone service would be usable by everyone and make it easier on the end user to use the service.
...
I expect that it is not dependent upon the addressing structure. I cannot say for sure, as I have not tried it.
If you do try it, I would love to know how it went.
Best of luck,
Bill
Look into APIC-EM.
http://www.cisco.com/c/en/us/products/cloud-systems-management/application-policy-infrastructure-controller-enterprise-module/index.html
Yanivaloosh,
I had the same issue and found that if you deactivate all services on both servers (see below) and then reboot both servers at the same time that will fix my issue.
Go to Cisco Unified IM and Presence Serviceability ->Tools -> Service ...
Pravin, I found it at this link. That is the DX?? admin guide. It walks you through the whole process. http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/dx/series/admin/1022/DX00_BK_C9FCBAE4_00_cisco-dx-series-ag1022.pdf
