Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Any one knows what this message means? will it have any impact on the router operation Police conform rate is adjusted to 20032kbps to meet the hardware supported precision Thanks
I'm trying to upgrade Nexus 5596UP to version 7 I used the commandinstall all kickstart bootflash:n5000-uk9-kickstart.7.1.1.N1.1.bin system bootflash:n5000-uk9.7.0.1.N1.1.binverifying image bootflash:n5000-uk9-kickstart.7.1.1.N1.1.bin for boot variab...
I'm trying to run BFD for OSPF between 6500E running version 12.2.33 SXH and Nexus 5596UP running Version 6.02. The Nexus 5596 has L3 cards and the correct licence. Here are the config6500:_________!interface GigabitEthernet7/17 ip address 30.30.30.1...
I have 6500E with Sup 2T, running the latest IOS 15.2.1SY1, I'm trying to configure ISIS IPv6 under VRF lite, but I'm getting an error message. test(config-if)# ip router isis%ISIS: Cannot enable ISIS-IP for process with mismatched vrftest(config-if)...
How about HTTP, does it work? You might have a problem with your MTU size.The simple way to check is to change the DF to 0 (create route map that matches all traffic and then set ip df 0) and test.
Show module Mod Ports Module-Type Model Status--- ----- ----------------------------------- ---------------------- ------------1 48 O2 48X10GE/Modular Supervisor N5K-C5596UP-SUP active *2 1...
