Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup an Isolated Private VLAN and running into some issue mixing the enterprise & SMB environments. I have a few switch ports I want to configure to talk to the internet only and not allow the devices connected to these ports to talk ...
I am wondering if someone can help me out as I am having a heck of a time grasping how to get this setup on this Cisco SG350 switch. I have 2 VLANs 130 & 150 that I would like to segment any type of Layer 2 traffic on each VLAN, one will be part of a...
I have 2 x SG500 52 port switches in a stack in my networking equipment room. This room is where all of my PC's plug into along with my internet connection & firewall equipment. My server equipment is in another part of the building with a 24 port SG...
I have a couple of questions regarding the use of the voice VLAN & autosmart ports. I was running into some issues getting this to work %100 in my environment. Here is my network in a nutshell,Single SG300 52 port switch, ports 1-47 are configured Un...
I continue to bang my head against the wall on this one. Everytime I try to connect to the AnyConnect SSL VPN I get the following error"No address available for SVC connection"I have verified up and down that my VPN pool is there and assigned. I have...
I am having this issue where I just had to power cycle the whole 4 switch stack. Just randomly in the middle of business hours I am running Firmware Version (Active Image):2.5.0.92 2147415954 2020-Mar-11 09:54:13 Emergency %AUTOSMARTPORT-F-DEV_CAL...
Here is my issue, I am trying to stop client A from talking to client B. I have Guest Isolation enabled on my UniFi AP’s and it works BUT only when two clients are on the same AP. If I have a client’s connected to two different APs they can talk to e...
I just deleted my Group Policy and added the DHCP pool to the default one and the issue was resolved. Thanks for the info, I think you are right on point!
