Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 2811CME. I want to run a XMLapplication on the webserver of the CME (example: to give the end users the weather of today).But I don't know how to put files on the webserver of the CME...My config is in the Attachement...Can anyone say ...
Can anyone explain me what's the cause of the error message?IP laptop --> 192.168.1.10IP Router --> 192.168.1.1I can ping to the router.This is the sh run output... So I have community strings:!snmp-server community public ROsnmp-server community pri...
I think I have a final problem with my configuration of netflow...It is difficult to explain my configuration so I put it in an Attachement...It is configured on a router (cisco 2620).If I use a snmp network tool I can see the router... So there is c...
Question of CCNA2 Chapter 10 (introducing to linkstate protocols)Can someone Explain to me why there are no 4 correct answers?To achieve network convergence, what three steps does each link state router take? (Choose three.) use automatic summariza...
I don't have much experience with configuring linkstate en distance protocols in real life, just in labs I do it. I am at CCNA2 now. But, what is the main difficulty of linkstate protocols? The configuration is almost the same of distance? right? Or ...
Solarwinds isn't caputre the data, the router send... The reason is, because the MIB number is wrong... I wont contact solarwins cause my english is not so good... Do you know another freeware software packet that can capture netflow packets, send by...
so, something is missing in my configuration you think?... I used this site to configure my router... I taked al the configure commands from"How to Configure SNMP and use the NetFlow MIB to Monitor NetFlow Data"But I don't understand how i have to do...
If I capture the packets from router to laptop with wireshark I can see the requests and responses... Everything looks fine. First he ask global information through SNMP:systeem descriprion(=SNMPv2-MIB::sysDescr.0 (1.3.6.1.2.1.1.1.0): Cisco Internetw...
Can anyone explain me what's the cause of the error message?IP laptop --> 192.168.1.10IP Router --> 192.168.1.1I can ping to the router.This is the sh run output... So I have community strings:!snmp-server community public ROsnmp-server community pri...
Hi Jan,I did the commands you told me to do.I put the output in a attachment...Is there anything abnormal in these output?Wich software would you use for capture the packets the router sends to monitor you network?Regards,Simon
