Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, I am new in WSA. I would like to ask for your advise on WSA healcheck. Usually what info do we capture for the healthcheck? Are all capture from GUI or some from Cli? If from Cli, is there any command? And also check on the failover. Th...
Hi, I am new on ESA. I would like to have more understand the email flow on the SMTP with TLS enabled. The exchange 2010 is currently using port 25. If I would like to change from port 25 to 465, and enable the TLS inbound and outbound, the below ...
HI I would like to know what does it mean in the data specification datasheet where for ASA 5525-X 3DES/AES VPN throughput is 300 Mbps. This 300 Mbps is referring to total throughput in and out or only referring to one way 300 Mbps? Please refer the...
Hi,
Does anyone have the idea what is Radius DNS in WLC? What is the function for this? I have gone tru the document from cisco, non of the document describe clearly and example of radius dns. Most of the document just tell you how to configure.
In self-registration portal, there are person to be visited (Sponsor's email) and visitor email column. However, there is a request in my site where the sponsor does not want to the approved email to be sent directly to the Guest. The want the emai...
I read through the Bugs detail, it mention the Network Setup Assistant 2.2.0.66 fixed the issue. You tested with ISE 2.4, but what is your Network Setup Assistant version? By upgrading your ISE to 2.4, it will not auto upgrade the network setup ass...
"You can use a fully qualified domain name (FQDN) that enables you to change the IP address when needed, for example, for load balancing updates. A submenu, DNS, is added to the Security > AAA > RADIUS menu, which you can use to get RADIUS IP informa...
