Cameron.Carlson
Level 1
Level 1
Member since ‎07-10-2017
‎04-18-2019

User Statistics

  • 16 Posts
  • 0 Solutions
  • 30 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

I would like to configure the CME for two external phone masks depending on the phone that is calling. EX: I have extension 1000-1006 2 Phone numbers 555-555-5551 and 555-555-5552   I want 5551 to ring 1000,1002,1004 - But when these numbers call out...
Breif: CME 7.0 on 2901  Connected, on the right vlan, can http, did fact reset, shows in arp table. still nothing I've tried 2 different firmware versions and manual entried. 3.02.04 and 3.02.00   On Switch: GC_Ghost_SW#sh cdp neighborsCapability Cod...
I have 3 VLANs setup on two of the VLANs I can not access any https website. HTTP working fine and so does icmp. VLAN 10, 14, 16   I have an ASA 5520, 2901, Autonomous AP and 3560g sw I have 3 SSID on the AP.  10 for Management 14 for users 16 for Gu...
I have an ISR 4331. I am replacing a 2901 with CME. I don't understand enough about what has changed. Do I have all the licenses and hardware necessary to control 10 phones on this router? 3 POTS incoming with 10 out. I had a nice GUI interface with ...
I am stuck. I can see where I create the Radius authentication on the Cisco side and on the Server Side. But I have to select a host source where the RADIUS request will come from. Does that mean I have to make a new RADIUS CLIENT on the server side ...
Community Statistics
Member Since ‎07-10-2017 11:36 AM
Date Last Visited ‎04-18-2019 10:28 PM
Posts 16
Helpful Votes Given To