Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Good day! May I request for technical assistance on the CISCO 7945 IP Phones that are in upgrading status of firmware, but it shows an error and doesn't proceed with upgrading.
I tried to do factory settings...
Hi,I would like to know how to synchonize/adjust the time settings of the CISCO IP Phone 7945? Is this being adjusted at the CISCO Call Manager our CM version that we're using is 7.1.5.35103-1. Currently we the time shown at our IP Phones is advanced...
Hi there,I would like to request for assistance. We are experiencing CISCO IP Communicator issues (CISCO IP Communicator version 7.0) wherein it cannot be installed in a laptop that is using Windows Vista and an error message appears that says that t...
Hi there,I would like to know on how to generate abandoned calls that are not being picked up by the CISCO IP Phone 7945? we have this LCS software installed, but I was informed by the supplier of our IP Phones that LCS software is mainly for generat...
Hi there,I would like to ask if anyone knows who to configure and allow 6 digit dialing in the CISCO Unified Call Manager Administration? Pls help and perhaps provide procedures... Thanks a lot.The CISCO Call Manager Administration system version tha...
Hi
Thanks for replying to my post. We could not set the DHCP and the TFTP server. This is usually found by pressing the settings button of the CISCO 7945 IP phone and editing the IPv4 Configuration, but I could not access the settings of the IP Phon...
The LCS Software that I'm referring to is the Logic Call Suite that our office will use for Call Accounting. It shows reports on incoming and outgoing calls only, but it doesn't show the number of abandoned calls, conference calls and the calls that ...
Hi,We have just launched a call center hotline that is 165-364 which has 6 digits and it is the PSTN. I'm trying to do it in our call manager but it doesn't work.
