Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I am hoping that Cisco experts can help me with understanding the following:- how and what NX-OS on the Nexus 5596 determines to be a link flap, i.e. how many port transitions within what time range?- does NX-OS use/keep a link flap counter?...
Hi Experts, I have a Nexus 5596 running 5.2(1)N1(1) (tried later release as well) in pure Layer 2 environment and I need to use SNMP to display the MTU size. A network-qos policy map has been assigned to the system's service policy defines the MTU...
Hi there, I have a Nexus 3064 running NX-OS 6.0(2)U1(2) and would like to enable Priority Flow Control on a few 10G ports. I cannot find any option to configure PFC, so I am wondering it is actually supported on the 3064. Thanks.Addy
Hi experts, I have a customer who is having some issues with 5m passive HP twinax cables, 537965-001, with a Chelsio 10G NIC. Aside from NIC driver issue, if NX-OS recognizes this SFP+, should it be expected to work in a 5020 running 4.2(1)N1(1)? ...
Colby, you may have misunderstood my question. I would like to downgrade the BIOS from 1.5 to 1.3 when downgrading NX-OS, but install all would not let me.
Simple L2 switch, LACP port channel 1 between ports 13-20. ISSU was able to proceed on sw2, but sw1 gave error on spanning-tree issu-impact. int po1 is root on sw2 but designated port on sw1.
prkrishn, thanks for responding. However, the problem is not because of incompatible version... Please check the output above for 'show spanning-tree issu-impact' on sw1. Thanks.Addy
