Hi everyone, i face an issue when I called a number in the pstn trough a at&t PRI trunk with a c2921 that is my gateway in a BE6000, in the settings of the phone the video capabilites is ENABLED, but the call innmediate fail, in the same branch also ...
Hi, I have an issue after upgraded the UCCX 4.X to 7.0 using the DMT, my customer tried to get the recordings of the calls from the agents, but when run the record viewer in the supervisor client got a message error "Following server is unavailab...
Hi,I tried to set a connectivity between 2 CUPS but the system troubleshooter mark Invalid inter-cluster proxy domains, this is the scenario; both CUPS are in the same domain (in theory), my customer have 2 head quarters, in each office have a CUCM w...
Hi all, I have a very strange issue here, after I read a lot of posting about the telnet problem no one resolving mine, actually I have everything configurated, well is not much, but I do not have any access list, no firewall between, only nat an...
Hi everyone, I Have two sites in HQ I have a C2801 as Hub, and in the remote side I have a C1861 as spoke that is getting the Ip through an ADSL , after I configured both rtrs, all Steps in Phase1 are complete, at the next Phase, I get the error IKM...
Hi, I have the same issue, I just install a new clean CUCM 9.1 and CUC 9.1 in UCS C220 with pre-installed esxi 5.1, I leave the clients site the last Friday and today say to me that the servers is down, just turn on the server and everything comes ba...
Hi Everyone, I have the same issue, is a new clean installation with the upgrade of the dev. pack I can add all the phones but stills in register, with others phones is working fine 7965 phones and CIPC, any answer with thiss issue. Best regards. CG
After I opened a SR with TAC I have to upgrade to SR5 in order to fix a lot of problems that the TAC said it fixed with the SR. And in fact torough the Cisco Database Administration in the Server I removed the other servername and put as Default the ...
Hi Michael,Another big 5 star thanks!, yes the way the domain change was modify the FQDN parameter, I assumed that the change in the proxy domain change automatically the FQDN, altough the federation is not work here.Thanks, Cesar G.
Hi Marcin, yes but theres something strange, because the configs are almost the same, the way that I have to force to work is, I erase all the configuration and re-enter, and automatically work, before I did this I force to activate the tunnel and I ...