About don_crowder

don_crowder · 10-12-2012

Hi all,I am having an issue with inbound SIP calls connecting very slowly. After a call is initiated, it can take anywhere from 10-15 seconds to connect. In the IPIP Gateway (3845 Version 12.4(24)T6), I see the call hit immediately but I am getting a...

don_crowder · 12-21-2011

I'm having some difficulties getting outbound SIP calls to work properly. When I dial the number, it rings once and then goes to fast-busy. The phone on the other end recieves the one ring.Here is the call flow:CUCM---->H.323---->CUBE---->ProviderI f...

don_crowder · 06-08-2011

Hi all,We've experienced a strange event and i have no idea how or why it happened. We had a subscriber receive a message in their inbox that was stamped from an internal user, but the message actually came from off-net. I've looked at the CDR and Un...

don_crowder · 05-16-2011

Greetings,Running CTIOS 6.0 and are having problems montitoring about a dozen or so agents. Last week, I visited a site that was experiencing the issue and performed the following:Verified port was spanned with WireSharkUninstall / re-install CTIOS c...

don_crowder · 04-13-2011

Hi,In the process of converting our branch offices from H323 to MGCP and have hit a road block. It seems that incomming calls on my FXO port are hitting an h323 dial-peer rather than the MGCP dial-peer. If you dial the number it just rings continuosl...

don_crowder · 02-28-2014

Sorry to reopen this old thread, but 7940 / 60's don't appear to be listed in the compatibily matrix. I trust you guys when you say that they'll work, but I'm wondering what firmware version they'll need to run?http://www.cisco.com/c/en/us/td/docs/vo...

don_crowder · 10-15-2012

It was a dial-peer issue... Thanks for pointing me in the right direction!

don_crowder · 12-21-2011

I inherited this setup, so my predecessor made the descision on using h323 vs a SIP trunk. Until recently, we have only been using SIP for incomming, but now we want to use it for outbound as well which is the reason for my current situation. Thanks ...

don_crowder · 08-12-2011

Hi Steven,Enabling a direct transfer to an extension as actually done on the subscriber configuration page. Got to Subscribers-->Call Transfer-->check radio button "Yes, ring subscriber extension". If you have multiple subscribers you can use the Uni...

don_crowder · 08-04-2011

Have you configured the attendant dn on the gateway config page in CUCM?

Member Since	‎02-09-2011 08:08 AM
Date Last Visited	‎07-28-2020 11:41 AM
Posts	34
Total Helpful Votes Received	5

User Statistics

User Activity

Inbound SIP slow to connect

New to SIP; Need some help

Strange incident Unity 4.2.1

Silent Monitor error code = 0x00000005

Incomming calls MGCP FXO matching h323 dial-peer

7940 and 7960 support in CUCM 9.X

Re: Inbound SIP slow to connect

New to SIP; Need some help

Unity 5.x Directory Attendant question

FXO Incoming / Outgoing Setup for 911