Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,A customer is asking me if there is a way to use low-cost SIP ATA's such as the PAP2 to register on a CUCM via the Internet without a VPN tunnel. Obviously we can make these boxes work directly with the CUCM on the LAN or via a VPN but the cus...
So I have a DMVPN network with 2 hubs (2821's). This setup is used for VoIP applications over the Internet for teleworkers. At the main hub site I used to have only 1 Internet feed which was DSL with a static IP. Now I have 2 WAN feeds for this sit...
Router is 2821 with DMS-100 PRI in Canada (no TCAP DB here). I am receiving NOTIFYs with Connected Address & Display IE's from the switch. This info is relayed to the CUCM in MGCP mode but not in H.323. Is there a way to get Called ID updates on th...
I have a CUCM 8.5 system with many sites linked together by a meshed network. Here's the breakdown:Site 1: Has Pub+Sub, ISR running CUBE for SIP trunk to ITSP (PSTN)Site 2: Has Sub, ISR with PRI (PSTN), local conferencing resources on the ISRSite 3:...
Hello,I am trying to retrieve a parked call on an SCCP ANL phone off an EVM-HD-8FXS (or a VIC2-2FXS for that matter). I park a call using a 7962G, take the analog phone off hook, dial the park-slot number, dead air. I try to press the hookflash, no g...
Bumping this because I just ran into this issue, and this post helped me out a lot... here's a quick & dirty solution, and an explanation of what I think is going on with CUE when integrated to a CUCM (imho).My gateways (CUBE, MGCP, H.323) all have a...
Bumping this... anyone?I tried setting up a H323 trunk with QSIG between my CUCM & my gateway just for kicks, but this breaks the PRI side of things (Incompatible Destination cause code).
I did in fact look at this document, but "Name-to-Follow" is specific to NI2, and isdn supp-service name calling just tells the gateway to use Facility IE instead of Display IE for CNID. h225 display-ie ccm-compatible is pretty much the same thing, ...
Wild guess, but have you tried updating VMWare Tools? There might be something funky with the virtual network interface.Sent from Cisco Technical Support iPad App
If your CUBE router has IOS 12.4(24)T or later you can use the credentials command under sip-ua to generate a REGISTER using an E.164 number. No need for an ephone-dn or a pots dial-peer.HTHSent from Cisco Technical Support iPad App
