Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.
Standing up a Intersight Connected Virtual Appliance (ICVA) 1.1.5.0, it is asking to register to Smart Licensing. The customer uses a CSSM, and the ICVA appliance only has internet access through the customer's proxy. It only seems to let m...
Hi all.
Very simple question, I am getting mixed messages about the above? I can't see any where from the GUI or CLI commands to replace the HX Connect self-signed certificate with a customer signed one? Has anyone done it, or knows if it can be don...
Hello all. I have a client who has the following scenario. CUCM 10.5(SU1)UCCX 10.53945 H.323 Gateway The following call setup is as follows and is very straightforward. Inbound PSTN call to the UCCX via the H.323 gateway and then CUCM. CUCM routes i...
Hello all. I have the following scenario. CUCM Cluster – 11.5(SU5)SME Cluster – 12.5(SU2)CUC Cluster – 12.5(SU2) The CUC cluster is integrated into the SME cluster, not the CUCM. My problem is simple. The CUCM cluster transfers an on-net call to a CU...
Hi all. I have a customer that is collapsing back their 3 x CUC clusters to a centralised one hanging off their existing SME cluster. We are just in the pilot phase at the moment but I cannot get MWI working from the CUC to the SME and across to the ...
Found the issue, it was because the inbound CSS for the CUC trunk to the SME didn't have the Global Learned E164 Numbers partition for ILS learned E164 patterns. So it was that easy!
Hi Martin.I am experiencing this exact problem on a 12.5(SU1) cluster after I did a PCD migration from 10.5. Did you ever find the cause and fix of this issue?
You are all good to upgrade your Expressways to 12.X, I had it officially confirmed by TAC it is supported on CUCM 11.5. Moreover, I have numerous customers using this combination with no problems. Expressways are being used for B2B, MRA and Hybrid C...
For this particular customer all three, they have 4 Expressways connected to their CUCM 11.5 cluster. They have no plans to upgrade to 12.5 until it is more mature, but would like to keep their Expressways current.
Hi Ehab.
I have a customer with numerous sites using an ISR 29XX or a 43XX using E1 interfaces. They have a centralised StoneFax solution in their data centre. I have T38 dial-peers that point to the StoneFax server directly and bypass CUCM altoget...
