Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
i have a cissco spark configured and associated to my DN.
As remote destination i have my spark sip URI.
Problem is desk phoen and spark app will ring together even if i set wit timer=30.
CUCM version is 11.5
I would like spark app will rin...
Hi Guys,
any of you know how to triggre the ceRedunEventSwitchover traps.
i'm not able to receive this trap using redundancy switchover command
Regrads
Hi Guys,
is it possible in ASR 9912 (2 RP Trident) configure a bundle beetwen the MGMT0 of RPACTIVE abe the MGMT0 pf RP standby and assign the ipv4 address to the bundle interface?
Regards
Alessandro
Hi Guys,
i should create a remote access (anyconnect) using mixed local and LDAP authentication.
Some user should authenticate using local credentials Others using LDAP credentials.
I have a couple of question:
1) Can I force ASA to chech LDAP adn...
Hi to All,
hi have a cisco ASR9001-S with the following softarware:
RP/0/RSP0/CPU0:CA5-ASR9K-BGP-01#sh install active Fri Jul 15 05:40:29.841 UTCSecure Domain Router: Owner
Node 0/RSP0/CPU0 [RP] [SDR: Owner] Boot Device: disk0: Boot Image: ...
Not at all dear Jonathan,
spark deviuce has a DN but it rings by using remote destination (SIP) uri.
I found out how to get the wait timer to work.
1) User-->enable mobilty
2) create a remote destinatio profile
3) in rd device delete and crete the ...
Hi Eddie,
first of all thank you for your kindly reply.
For sure i enabled all the traps you wrote down.
I think, but not sure, manual switchover does not trigger this trap
Regards
