Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 7609 with a WS-X6748-GE-TX. When I show the port capabilities I can see rx-(1q8t), tx-(1p3q8t)If I show queueing on an interface I see all the WRED and WRR queue configuration.This is great, I can make changes and view changes.I also have...
Hi,I have a 7609 with multiple VRFs (VRF Lite).Below is a sh modMod Sub-Module Model Serial Hw Status ---- --------------------------- ------------------ ----------- ------- ------- 1 7600 ES+ DFC LITE ...
HiI had a problem with the cluster after upgrading the to 6.1.3a.I added a new sub to the cluster. It installed fine however under dbreplication in rtmt it showed a status of 0.I opened a tac and the last action plan was to perform a utils dbreplicat...
Hi,Can anyone explain then following output.I have searched the command reference and configuration guide but they do not explain the five coloums showing packets. Are these tansmits, drops, queues.ThanksAnthonysh mls qos interface f0/13 statisticsFa...
Hi,When I run the command below I get no statistics. Can anyone tell me if I need to configure the switch to enable this (enable) sh qos statistics 5/1Tx port type of port 5/1 : 1p2q2tQ3T1 statistics are included in Q2T2.Q# Threshold# Packets ...
