Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had to abort a production deployment of a Meraki cloud-managed Catalyst 9300 stack because the configuration is lost after a reboot or power cycle.The stack has two C9300-48UNs and four C9300-48Ts running IOS XE 17.18.4.1. It works normally until ...
Is anyone else facing this issue. On every shutdown on Windows 11 Windows display a prompt and Webex must be force closed.The bug details are limited but seem to detail the same issue I am facing. However it suggests the issue is resolved but I am ru...
Is anyone else having issues setting custom APN details on MX (and Z3C) units with in-built cellular modems?We have had an open case since early May relating to being unable to set custom APN details. Details can be set within the dashboard and local...
We have a large majority of 7940/60 handsets still running CUCM 12.0. I know a range of handsets were depreciated with the release of version 12. We are trying to plan for the replacement of these handsets, does anyone have any details around depreci...
Hi All,I am working on migrating our gateways from ISDN to SIP using SIP trunks from Virgin media. I have all working well apart from an issue with MOH on inbound calls causing the call to drop.Call fllow as follows..IP Phone > CUCM > SIP > CUBE > SI...
@Singhaam Thanks for sharing your experience.All of our switches were Meraki SKUs and came pre-loaded. We did, however, encounter an issue during the upgrade process. At least some of the switches were running CS16, and the target network had already...
Hi Giuseppe,Thanks for replying. Cisco docs seem to suggest 8 is the maximum stack members, do you have a source for this?Once the cloud config has synced the stack was working as expected with the 6 member switches.
This script stopped working for us (with the same error) some time back. We never did get the time to troubleshoot and update. v0 of the dashboard API is now sunset and you'll need to update to work with v1. If you do get it working let us know what ...
PPPoE sorted at least. Turns out there is a bug which was fixed in 18.107.3 which causes the WAN port to be disabled when the PPPoE credentials are set. The challenge with that is you have to re-enable within the dashboard but unless you connect up a...
