Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,I am try to set up my ccie lab. with 5xrouter, 4xswitches. and the problem is from time to time, my devices console will not be reachable. I can only access my access server, but none of my router can be reach. it show up a error of remote connect...
hi all, I am setting up my ccnp home lab. I have 4*1841 with wic-2t(smart serial) installed, and 1*2610xm with nm-8a/s intalled. I want to use my 2610xm as frame relay switch. but when I tried to set the clock rate on the serial interface, it pop up ...
hi all, my 1841 router can't resolve dns after enable ios firewall, I try to ping google.com from router's console fail, but dns resolution is fine from lan side. what could be the cause? my partial config---------------------------------!ip name-ser...
hi all, my ISP provide me a NAT modem, it's not replaceble! so I can only connect to the LAN of the Vodafone modem. therefore, my cisco 1841's WAN interface got a private IP. topology: actual LAN switch---->cisco 1841(NAT)<-->Vodafone modem(NAT)<--->...
hi all, I bought a used 2610xm and install with NM-8A as my frame relay switch. and my 1841 has wic-2t installed. but I don't know which cable I need for connecting both device via serial? I checked datasheet, but still not sure which cable I need. C...
THANK YOU PETER!!! it works!!R1#ping 10.1.1.2 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.1.1.2, timeout is 2 seconds:!!!!!so exciting to see above result now I can continue my frame-relay lab.. thank you again, I spent half d...
hi Peter, I just recheck my cable... sadly, I seems bought wrong cable. on DB60 end as DTE, SS end as DCE.. I bought 10 of these cables, is anyway I can still setup my lab? I try to set my 1841 as DCE with clock rate(but it show me another message as...
hi, you cannot specify a source from lan interface when ping to a domain name. (I just tested, it only work with ip)for example: ping 8.8.8.8 source 10.2.1.1 <--- this is okping yahoo.com source <---- this sub command source will not work
