Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue with receiving a notification for new voicemail messages of operator extension "0", while there is no issue with any other extension, the issue is for this extension only, what may cause this issue?, noting that the email notification...
when installed Cisco IP Communicator 7.0.6 on windows 11, it can't work and give a message
Audio Tuning Wizard
" is either missing or not connected properly, please reconnect it and select OK.
To select a different device using Tuning Wizard, select ...
I had configured BACD on ISR4331, and when prompted to select option 1 and dial by extension, the call is forwarded to the extension successfully, but when press 0 to reach to the operator the call is dropped, what may cause this issue?? below the BA...
i am trying to register a Cisco WebEx DX80 to WebEx cloud but it give me a message Not able to contact Webex service. A firewall may be blocking this system from connecting
Hi Carlo,
i removed destination-pattern 666, session target ipv4:1.1.1.1, but it didn't work, but let me share with you a good news, where i had enabled "Check mark" the option Media Termination Point Required in Gateway configuration settings in CUC...
Hi Carlo,
i had removed the port under new dial peer but unfortunately the same result,
if i understand removing Plar under voice ports well, i had removed connection plar opx 666 from old dial peer, but in this case the call didn't reach BACD, it dr...
