I am getting the following message on boot up of a PXM45/C card ************************************************ This CARD NVRAM is not programmed correctly** Program the NVRAM using the DIAG image ASAP* System WILL NOT come up if this continues* Fr...

I have a couple N3Ks that I am getting no console output from them and the LED on the front just blinks blue. I have tried re-seating the RAM which has helped in the past with some units that would stop booting, but in this case I am still just getti...

Both Slots 15 and 31 show as Unknown card when no card is installed front or back . I have tried clearing out the config using "clrallcnf" as well as "clrsrmcnf" (had to install a SRM to run this command) so far nothing has worked to make these slots...

We are attempting to install a 3rd party (Juniper 100GBASE-ER4) 100G optic into a Cisco A9K-2X100GE-SE os Ver 5.1.1.  We are trying for a good loop back test however it keeps failing.  Does anyone have expertise in this area of getting a 3rd party SF...