Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm configuring my very first 2nd Generation 2901 Cisco ISR, and trying to set it up with CIMC-E. However, when I set up an IP address of 10.5.128.200 for the embedded-services-engine0/0 interface, it returns this error: % 10.5.128.0 overlaps ...
Here is the config.Problem is they cannot get to the internet. All internal networks are functional. HELP!Result of the command: "sho run": Saved:ASA Version 8.4(1) !hostname *******************domain-name *************************enable password ***...
There is a thread where a gentlemen running CUCM 8.0.3 here: https://supportforums.cisco.com/message/3182594He got it to work.Basically I'm getting an error message that says "Personalization is disabled on the selected device" whenever I try to push...
Is there one? Can't find this with google for some reason.Also, if I have 11 sites using traditional T1s with MPLS, and I add another site using EoC, will it run on the MPLS network the same?n00b questions, bear with me!
I've been trying to get this WS-C3560-24P-L switch I have to enable IP routing. So far I've been unsuccessful.I've tried the IP base IOS and the Universal IOS. I do not see any other type of IOS to download on there website.Am I missing something?
This router has sub-interfaces for the 128 - 135 networks.Are you saying I have to place it on a different network than ALL of those? I'm confused. Can you help elaborate?
Yeah I forgot about subinterfaces. Also, I joined it to a VTP domain by doing this:config tvlan databasevtp domain XXXXXXexitAs you sort of mentioned above, with it's limited capabilities, I needed to actually be in vlan database mode to change the v...
Sadly, none of these answers are correct yet.Yes I can get into the vlan database and create a VLAN, HOWEVER, I cannot create a VLAN interface or change the VTP domain.I can see show vtp status....but the normal commands don't work.Is there anyone wh...
