Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Z4C already configured for cellular. I'm not trying to connect the WAN port to my home internet via cat6 cable. The cable has been confirmed working as it came from a working Cisco Phone. I read the WAN port is set to DHCP automaticall...
Running vs 1.3.3.6 DNAC and using the syslog feature in DNAC (Design>Network Settings>Network>Syslog). Looks to be using port 514 by default. Is there a way to change
We have port security turned on:switchport port-securityswitchport port-security maximum 2switchport port-security violation restrictWe were getting an error on the port (with only 1 device connected to this port):Sep 16 15:49:42: %PORT_SECURITY-SP-2...
We might be okay. The event just cleared when I ran the same command for the other card. Output:I-Card_Fault_CiscoEntityFRU-CARD-123.133.187.1/1000I-Card_Fault_CiscoEntityFRU-CARD-123.133.187.1/2000I-Card_Fault_CiscoEntityFRU-CARD-123.133.187.1/300...
