Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I deployed prime LMS 4.2.5 on soft appliance in our lab and trying to learn few things. I would like to know how to enable Energywise on LMS 4.2.5. The “Readiness assessment” under Energywise is showing the below:0 EW Capable Devices0 EW Enabled D...
HiWe are trying to do appliance backup on Prime 2.1 and restore on Prime 2.2. Getting the below error:Current system configuration doesnot match the system configuration of the machine where the backup was taken.Please attempt restore again on a equi...
Hi,The fans 1 & 2 in Module 1 on the Nexus5K are still experiencing the very high RPM and speed issue.I have replaced the fan from another operational Nexus5K, and the fans are fine in the other Nexus. The replacement fans also have the same issues, ...
Hi Guys,We are using Cisco 2921 router with universal image and uck9 license. We have configured the device to push the cdr files to the ftp server.gw-accounting file primary ftp ipaddress/dev/can/cdr username xxxxx password 7 xxxxxI can see the cdr ...
Hi Guys,I have 8 access points and a 5508 series WLC. I am getting the below alertsMessage: Interference threshold violation reported by '802.11b/g/n' interface of AP 'KPAP0000.f4a6', connected to Controller '10.69.186.21'.Message: Interference chang...
After restarting the application, 3750 is showing as "Energywise software Incapable device". But still 3850 is not showing up.0 EW Capable Devices0 EW Enabled Devices1 EW Software Incapable Devices0 EW Hardware Incapable Devices3850 is running the co...
Thanks Ernesto.But my issue getting started assistant is not displaying EnergyWise-based device details after assessing the network. I upgraded from 4.2 to 4.2.5 for 3850 support. On 4.2 version it was displaying "3750 Version" as incapable version a...
Thanks Ashok and Andy.But I am not able to locate anywhere in cisco P2.2 guide that the specification need to be the same. Is that mentioned somewhere on the cisco doco?Both have 16 vCPU and 8192MB memory. Does the VM version and memory overhead requ...
