Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Well this is an interesting one, i have a tunnel configured between two 2921 routers that used to work just fine, we had an management access issue on one of the routers and it had to be rebooted, all looked fine until one of OSPF adjacencies...
Good Morning all, I have a TAC case opened for this right now but I thought I would share it as TAC at this point aren't able to resolve it.I cannot issue the write memory or copy run start command on my 4500X VSSPRD-SWCR01#wrstartup-config file open...
Hi Guys, Im having a weird issue with ssh from a cisco 1941 to a cisco 1941, it used to work fine, but now it hangs...we have two routers at each site, one primary with an EOC connection to the network, and the other a backup 3G wireless connection t...
Hi Guys,I have a 4500X VSS core in my lab ready to implement, i'm doing redundancy and failover testing at the moment, and im wondering....I have emulated an active sup failure by pulling the power plug on the active switch,now cisco does not recomme...
Hi Guys,I have created a policy to match certain flows for our business, then assign them specific bandwidths, all is working well, except for one thing, almost 10% of packets are making it through to the class-default, even though i have an ip any a...
Ok, sorted, i had ip ssh source address set to a loopback, the 3G router never knew how to get back to the source, when the 3G connection was brought up, ssh went all the way back through the core to the primary routers ip ssh source address!thankswa...
Just to follow up so this isn't a dead thread, it was the card jumping between GSM and WCDMA, it was confused and eventually shut itself down, this particular site has very limited coverage so specifying what band to stick on fixed the issue.isa-rt02...
