Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an issue that I can't seem to figure out. The scenario is as follows:A WLC 5520 is used for FlexConnect only and that works 100%. But, when we added new APs and configured them in local mode the guest network could not provide users with IP...
Hi all! I got a fun one today I was updating our ISE cluster with two admin nodes and two PSN nodes. The primary admin node and one of the PSN nodes was updated from 2.4 to 2.7.9.356 but the update halted when the remaining PSN node had low disk ...
Hi all! I seem to be missing the option for Health check on my ISE 2.6 server. Usually it's accessible through the GUI, Administration - System - Health check. But the menu is gone and also the option to do it under the post upgrade review. Any idea...
Hi all! I've found an issue I can't seem to figure out. DNA center warns me that the connection to the pxgrid on an ISE server has stopped working because of an expired internal certificate, but when I look at the internal certificate in DNA center i...
Hi all, I'm planning on upgrading four ISE servers in a cluster from 2.4 to 2.7 that are running on VMs. Is it possible to upgrade it by removing a node and then installing a new one with the new version to then add one by one replacing the ones with...
The reason for the BGP part is that the bottom switches are supposed to be connected to NSX-T and they "require" BGP peering to work. But this seems way to complicated to be needed I've attached the suggested design.
Hi, The core is 7200 and the "top of rack" devices are 9300. So I should just be able to enable it per interface in that case? But I can't just add the new VLANs to the current uplink channel-group interface right? What are the commands in that case?...
