Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I configured ezvpn on router to provide connectivity to remote user. I defined pool range 172.16.100.1-20 and enable split tunneling. Remote site (from where users are dialing) is having two local networks there i.e. 192.168.1.0/24 (users network)...
Hi,I configure some local users in router for ezvpn x-authentication. But i want these user cant telnet into router. I can restrict users up to some extend by configuring users with privilege 0 but still user can run show commands. My requirement is ...
Hi,I have two gateway routers that are connected with L3 switches. R1 with SW1 and R2 with SW2 R1 R3 SW1------SW2R1 f0/0 10.1.1.1R2 f0/0 10.1.1.2SW1 vlan10 10.1.1.3SW2 vlan10 10.1.1.4R1 and R2 are connected with provider via bgp and c...
Hi,I have IP telephony setup includes callmanager 4.3 with IP phones and 2811 as voice gateway.I configured digit 9 to make offnet calls now the problem we are facing when someone from pstn call on DID number, calling number saves in received calls. ...
Hi Friends,I have IP Telephony setup in my office that include Cisco 2811 as CME and voice gateway with PSTN through E1 PRI. Now i want to integrate Polycom VSX7000 video conferencing device with IP Telephony network so that i would assign extension ...
Hi,My requirement is that active switch should forward traffic to both routers and loadbalance. I cann't change HSRP with GLBP or HSRP multiple group because of some limitations. One solution could be possible that i can configure on switches per-pac...
Hi,Yes i studied polycom documentation and now on the result that device should be register with some gatekeeper but now i am not confirmed how i will do that. Should i configure my CME also as gatekeeper or what?Please if you can assist me in this r...
