I have many BE6K installs which are deployed in remote sites, can i use PCD to install CUCM cluster, CUC and CUP remotely? Any recomendation? Thanks Justin ... View more

Can I register handset SPA302D without SPA232D ATA via SIP? I will be using Asterisk, and we have a separate FXS/FXO gateway.   Thanks     ... View more

We still have CIPC deployment (Yes, we havent migrated to Jabber) our customer wants to synchronize Outlook Contacts to their CIPC (Cisco IP Communicator) they have some Windows XP, Windows 7 and Outlook 2011. We have read in forums that PAB plugin is no longer supported in Windows 7 due to the lack of Windows Address Book. Anyone can comment into this? I have CUCM 9.1 and plugin still available, ... View more

Hi all, Im following this document: http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml#lanbas http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/ha_active_standby.html#wp1097252 the scenario I have is the following: Cisco VCS -inside- ASA-a -outside- Cisco VCS-E                   1.1.1.1         2.2.2.1   I'm planning to configure active/standby with failover link crossover cable. If I add a second ASA It will be linke this:                   1.1.1.2 ASA-b 2.2.2.2                                 |                                 | 10.10.10.2 (stateful link)                                 |                                 | 10.10.10.1 Cisco VCS -inside- ASA-a -outside- Cisco VCS-E                   1.1.1.1         2.2.2.1 From document it only uses the outside interface. [Question] Do i need to specify my internal IP address to do failover as well? From DOC: In this example, the outside interface of the primary PIX is configured this way hostname(config-if)# ip address 172.16.1.1 255.255.0.0 standby 172.16.1.2 Here, 172.16.1.1 is used for the primary unit outside interface IP address, and 172.16.1.2 assigns to the secondary (standby) unit outside interface. Thanks ... View more

How to enable SIP debugging in ACE appliance. We recently implemented an ACE, 1 SIP VIP and 2 remote servers. We want to see SIP messages processed by ACE appliance. Thanks! ... View more

I upgraded my 797X from 8.5.3sr1 to 9.2 and now they use the Secure Authentication/Directories URL using https instead of regular http port 8080 is it normal? I dont find it documented. ... View more

I have multiple customers in US which want to connect to remote offices outside US. How can I offer Callway to them so in remote office they use the same endpoint for local dialing or international calls. Example: Need my CallWway endpoint to use my local PSTN resources in each office is this possible? ... View more