Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears
recently we add around 65 access points(1552 requalarity is -M) in outdoor area , after installtion I found too many MAPs rejoining and chainging its parents frequantely . then I found RADAR signals effeceing on 100,104,112,136,140,149,153,157...
I am trying to create a policy for some devices to be dynamically assigned to vlan 10: The Wireless Client connect with CWA (VLAN 200) ---Rule After successful authentication if the username from guest identity group , the wireless client wi...
Hi all; I have one H323 gateway and one CUCM 10.X, as I have two groups of users A, B. how can I configure the system to route the calles as follwoing : Group A will use FXO 1Group B will use FXO 2 any suggestion will be appreciated
it is very useful post , but the command screen /dev/cu.SLAB_USBtoUART4 9600 can be different. in my cas it is screen /dev/cu.SLAB_USBtoUART5 9600thanks
Thank you amine;but not that I need, I need from the IP phone itself when the end user press 9 to do FXO call, a sort of tone start to tell him there is line or there is no line free.I hope I could explain my issue in the correct way
