Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've read the release notes for the new firmware for the ATA-187 (9.2.3) which supports plus dialing by using the '*' (star) key. However I've tried installing this firmware to test the feature, but the star key doesn't seem to be past to CUCM.I inst...
Hi all,I'm working with a customer that used a (star) * in there dialplan. The issue has risen now that they have purchased quite a few ATA-187 for remote locations for analogue phones, because the (star) * is interpreted by the ATA as a local speed ...
Recently I have been asked a question by one of my clients, are there phone localization for CUCM and what is the benefit in installing them in Australia?I know that for non English speaking countries there are phone and gateway localizations to ensu...
Hi all,In earlier versions of CUCM 6/7 under the compatibility matrix, there was recommended IOS versions for use on the voice-gateways for CUCM 6 and or CUCM 7. I had this link bookmarked.Now working on a project that's using CUCM 8.5 but my link to...
Hi Maurice,
Can you remove the section of configuration below and retest?
policy-map SHADE_2MB
class All_TRAFFIC
shape average 2000000
service-policy PRIORITY
It is calling the same policy-map, and I'm wondering if it's interfering with t...
When I was referring to clients I meant customers. I was comparing the features to MS Lync. If you look at the old IM system Spark, it is more feature rich than Jabber, it allows end uses to upload there own photos from Spark for all to see, it inclu...
It does seem that feature parity with Lync is not high on Cisco's to do list. Look at the feature list improvements from 9.1 to 9.2, really how many people are involved in the Jabber client build project, 1 or 2?This thread is 12 months old, and stil...
Hi Jim,If you have more than 1 CAS server, you will need to add them all. I'm assuming your using EWS mode not OWA. How to Enable Authentication on the Exchange 2007/2010 Virtual Directorieshttp://www.cisco.com/en/US/docs/voice_ip_comm/cups/8_0/engli...
