Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,On 9.1(2) CUCM with PUB and SUB i noticed an interesting issue with callback feature that i haven't figured out yet, please see the attached picture.As you can see timezone and date format is wrong at callback service output comparing ...
Hi everyone,Our customer (and i) complains about slow call setup when doing outbound calls from SPA phones on UC560-BRI-K9.User types the called number and presses the Dial button on the phone and it takes around 10 seconds for the call to go out on ...
Hello everyone,We have a standalone CUCM 7.1.5 with 2911 CUBE (Version 15.0(1)M2) installed together with 15 SIP phone model 9971.Outbound calls from 9971 SIP phone works fine.Inbound calls from PSTN to SIP phone fails at CUCM side.In this case we ge...
Hello everyone,We have SPA502g phones registered to UC560 (version 8.6)users want to create personal Speed Dials on SPA502g phone via phone menu as per user manual, You can use the phone menu to add a speed dial that is not associated with a line bu...
Hi everyone,We are testing cisco gear (UC520, UC540, C2811, C2911, C3945) with one of our providers. We have a problem with sip trunk registration. topology:[CISCO GW or UC520] <--via sip trunk--> [SIP proxy-provider] <--via sip trunk--> [Siemens Hi...
Hi Raphael, We have a similar situation.WLC5508version: 7.6.130.0AP: AIR-CAP2702I-E-K9 Can you confirm that upgrading WLC to 8.0 resolved the "Previous authentication not valid ReasonCode: 2" issue on endpoints? Hope to get you feedback, thank you in...
Hi,CP-7821 should be supported on cucme 10.0:Cisco Unified IP Phone7821 SIP78xx.10-1-1SR1-4Requires IOS 15.4(1)T and later Fast Track SupportCisco Unified IP Phone7841 SIP78xx.10-1-1SR1-4Requires IOS 15.4(1)T and later Fast Track SupportCisco Unified...
Hi all,As you ca suspect, we have a similar issue, and can't find the cause for it. rajesh.kumar, did you resolve your issue?Hope to get some feedback,BRAles
