About skelley5000

skelley5000 · 07-27-2015

I am seeing this on one my uplinks on a 3850 I currently have up and running. This is a layer 2 connection that is trunked with a 3750, both ports on each switch are configured for the correct VLAN's but one thing I did notice is the uplink on the 37...

skelley5000 · 12-16-2014

I have 4 radius servers setup on my switchMy question is I believe if there is no response from the first radius server it will try the second and so on, but what if the authentication is rejected will the switch still try the next radius server?

skelley5000 · 05-14-2014

I am adding my Cisco 3750's into prime and I would like to enable NMSP fro each switch using prime.So far I have only found the way to do this is by editing each switch once Prime has synchronizing with the switch. Is there away to do this in bulk? I...

skelley5000 · 03-31-2014

I upgraded my controller and pre-downloaded the image to all of the AP's for a later reboot. When I try to reboot the controller I get the following message.AP software being upgraded, please try again later All AP's show the image has been pre-down...

skelley5000 · 03-05-2014

I started planning to upgrade the code on my controllers with a certain code that I felt would be right for my company, but after talking to my Cisco rep we decide to move a newer version.My question isI loaded the code I thought I was going to onto ...

skelley5000 · 04-23-2024

If I export a map from prime and import it into DNAC will the exported floor plan retain its measurements or is it just the map?

skelley5000 · 06-03-2014

I set up Discovery with all of the different sites, input the correct user name and pw for telnet for all of the devices. Majority of the devices work fine but under device work center I see a lot of device with the wrong CLI credential error. When I...

skelley5000 · 05-28-2014

I would like to move an AIR-LAP1142N-A-K9 which it is running IOS 12.4(23c)JA2 from an older 2500 WLC (7.0.116.0) to our 5508 WLC (7.4.121.0). I was reading the compatibility list and the AP is compatible but with IOS 15.2(2)JB3. When I move the AP ...

skelley5000 · 04-15-2014

That all depends on the version of code that is running on the controller, I started off with HREAP on our 5508 because I was running a 7.0.x.x version once I moved to 7.4 HREAP was converted to flex connect...

skelley5000 · 02-19-2014

well my question was how to stop an image deployment if you have chosen multiple switches instead just the one you want

Member Since	‎07-23-2012 02:04 PM
Date Last Visited	‎04-24-2024 12:05 AM
Posts	61

User Statistics

User Activity

unknow protocol drops

Cisco Radius

Cisco Prime NMSP enable

AP software

WLC upgrade

Re: Cisco Prime Infrastucture Map Export

I set up Discovery with all

I would like to move an AIR

That all depends on the

Cisco Prime 1.3