Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have deployed several Disaster Recovery systems for a customer, some are 1+1+1 and some are 3+3+1, using version 2.3.5.5.
After a failover, my templates are not visible in the Template Hub. It happened on each of my 5 DR system. Everything is d...
Hi,
some colleagues have setup 2 C9800-L in HA. Having a look at it, I saw they are still in bundle mode. So I wanted to move them to Install mode following the procedure (install add ...), but there is no package.conf in flash to set the boot. How c...
Hi,for an end customer, we have a GEN2 Prime Infra 3.5, and we are considering to enable HA.Since GEN2 appliance are going End of Sale by the end of june, I'd like to know if I can setup HA with one GEN2 Primary and one GEN3 Secondary server ? If not...
Hi,
in a Datacenter, I have 1 Operation Center and 4 Prime instances. I want to upload the bundle file to upgrade from 3.2 to 3.4, but I have a poor bandwitdth between my FTP server (laptop) and the servers.
I already uploaded the file to my Operatio...
Hi,I'll have to install 2 Prime Infrastructure physical appliance in HA.My customer is wondering if each appliance can be attached to 2 Nexus with an EtherChannel Link.I can't find any answer to that in documentations (Config Guide, AdminBook, ...).I...
So, after another webex with the TAC, the issue is located on the template hub page :
"we believe the issue is related to data caching by one of the microservices on Cisco Catalyst Center".
Only a cosmetic issue, as we clearly tested that synchroniza...
Hi @Gehrig_W,
for a customer, I upgraded from 3.10.4 + System Patch directly to 3.10.5 + System Patch, and I'm facing the same issue, not able to use "Transport Gateway Mode".
In the above method, last step is to reconfigure Direct transport, but my ...
Hi,
I don't know what is this HAR file, but I haven't been ask to collect and provide it to the TAC. And I've hit a new behavior that I didn't noticed yet :
1. I have a template version 2 in template history on my Main Active.2. New failover from Mai...
Hi
in my attached document, I performed the failover back to Main site and my intials templates created on the Main were still visible, but not the templates created on Recovery site while it was the Active site.
And since I had to proceed with my w...
And did you reboot all 3 nodes after deleting Virtual Drives ?Keep node 2 and 3 at the step where you choose your USB drive, and proceed to maglev-config with node 1.
