Just installed Cisco Jabber 11.8 and updated the jabber-config to reflect the recent changes on directory integration (EDI/BDI to CDI), but since the upgrade I'm unable to resolve contacts.
Directory Type: OpenLDAP
Bind: Bind successf...
I'm currently facing an issue with a SRST deployment because the DID ranges doesn't match the extension ranges.
DID Range: 12345XXXX
123450000 to Ext 1234
123450001 to Ext 4321
123450002 to Ext 9999
IOS has a limita...
I have a deployment with CUCM 9.1, CUCIMP 9,1 and Cisco Jabber 11.
I'm able to start a share desktop session from an IM chat/chat group with 2 or more participants. When I try to share desktop with an active call (2 participants), i've got no...
Hope you're doing well.
I've just tested with versions 11.6(2) and 11.7 (release today to CCO).
This is the tests result:
If the conference is initiated by a softphone, the conference is hosted on the Telepresence Server;...
We were using DSP Resources for videoconferencing and IOS DSP Resources doesn't support content sharing (BFCP).
There are two options:
Before setup the call, start the share on a chat window. This will use Jabber custom RDP protocol. The...
Hi,Please check if the gateway has a CSS that can reach the partition of the site that you want to call.You can use the dialed number analyzer (https://cucm-address/dna) and check the call flow; If the call is Routed, enable the SDL traces under the ...
btmulgrew, If you are using another SIP Trunks in your gateway, you shouldn't bind all the media/control globally.Like you have on your config, specify the bind under the dial-peers to the ITSP:You can use this command to do so:dial-peer voice XXXX v...