Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im trying to test adhoc conferencing on a newly installed phone system (UCMBE 8.x).I'm using the following steps:Dial participant 1, establish callpress confrn buttonDial particpant 2, establish callpress confrn buttonWhen I press the confrn buttton ...
I'm running 12.2(33)SXJ1 on a 6500 with several IPv6 BGP peers. Is there any way to monitor the BGP status of IPv6 peers? I've been through the BGP4 mib and cant seem find a way to check the status of IPv6 peers. Does anyone have any thoughts on this...
Good Evening/Morning,I'm looking for suggestions on allowing agents in a queue (say the Billing Dept.) to transfer calls to another queue (like Technical Support). Currently agents are calling each other's personal extension and transfering directly....
When using a CSM and SSL-M, which piece of the configuration is responsible handling client NAT? I have a need to NAT all client addresses as coming from the "loadbalancing network". Im currently configured to do that on the CSM for traffic leaving t...
Greetings,I'm in the process of configuring UCMBE for a small call center. We would like to have the folks who shifts to login to their phones so that their extension follows them around. We heavily rely on Microsoft AD, so naturally we intergrated C...
That bug does not apply to me.I dont see any IPv6 address when I query .1.3.6.1.4.1.9.9.187.1.2.1.snmpwalk -c sdasdadad -v2c XXXX.sctn01 .1.3.6.1.4.1.9.9.187.1.2.1SNMPv2-SMI::enterprises.9.9.187.1.2.1.1.7.XXX.XX.160.1 = ""SNMPv2-SMI::enterprises.9.9...
That is a pretty interesting alternative. I would assume I could use the PIN for security purposes since it is part of UCM?Do you happen to know if a documented example for creating this app exists?
