Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1. I noticed CDP on my workstation port I could see how this could be useful using a sniffer to know what port on a switch your are connected to. I found out running no cdp enable on that port prevent cdp advertisements on the port. Do most of you l...
I want to upgrade the Cisco UCS 5108 (PID and SKU N20-C6508) with the following blades B200 M1 (PID:N20-B6620-1) to the latest and greatest UCS Manager to 3.1(1h). I really need the HTML5 capability because the latest Java we installed considers the...
Issue: I have bad NTP on my Nexus 5548 no matter what device I point it at. I pointed it at my GPS device to which it should see because I see the mac address of the GPS device when I do a sh mac add | in 254. I then pointed the Nexus 5548 at two oth...
When I do a sh ver on my WS-3750X-24S I see this in the license portion: License level: ipbase, License Type: Permanent Next reload license Level: ip base
I have ran the command license boot level ip services so why is it not showing that when I do ...
I had a module line card die on me on Saturday on my 6509 and I had to plug all my access switches that had SVI's routing eigrp in to a 3750 (SW04). When I do sh ip route on the 3750 I see the routering tables from all the acess switches. When I do...
So you only want vlan 40/subnet 10.40.40.0 to go out your firewall 2? You want all other firewall traffic (vlan 20,10,30) to go out FW1? If so then yes this seems correct.
You do have it routing command turned on the switch right?
I have a oob mgmt interface configured but I do not want ntp to use it. I want ntp to use what it finds in it's mac cache since it see the ntp device there. I changed the command to ntp server *.*.254.80 prefer but when I use the command sh ntp stat...
I have this exact same problem except I am running this IOS: cat3k_caa-universalk9.SPA.03.06.04.E.152-2.E4. I am running the command from global mode.
Any clues anyone?
So I found the problem. It appears to be the version of the IOS on the switch (12.2(58)SE2 c3750e-universalk9-mz.122-58.SE2). This appears to be the lowest version of the IOS which does indeed only allow stub network and why this switch is not proper...
