Hello everyone,
I have an issue regarding the implementation of EVC using S-VLAN on a pair of 6807xl. I have configured EVC as per the instructions as follows:
1. Enabled MSTP using one instance for all VLANs
2. Enabled dot1ad globally
3. Enabled "...
Hello to the community,
We have a pair of 6807xl on our production network running a bunch of etherchannels using LACP. The issue is that we need to enable DOT1AD on these switches and from what I have read in Cisco docs, it is stated that LACP and...
Hi everyone,
MPLS over pure IPv6 network used to be one of the Cisco and IETF roadmap to come. Has it been implemented on different Cisco OSes so far and if it has been I would like to know whether L2 & L3 VPNs can operate on this infrastructure ...
Hi everyone,
Is it possible to terminate PPPoE sessions on a VPLS PE which is configured as a BRAS at the same time on ASR1002x? There is a feature in ASR9K called Pseudowire Headend for this scenario, but I am looking for a trick to solve this pr...
Hello everybody,
I have a question regarding the 6800 architecture design and that is whether the CAM table size of 128k is per line card or per chassis? The linecards are considered to be using DFC module.
Regards,
Hesam
Hi Nicolas,
We are comparing the feature sets between ASR 9910 and NCS 5508 and the price is much more affordable if we would go for NCS. So would you mind sharing a list of feature sets that we are going to lose as of now, if NCS is chosen.
R...
Peter Paluch saved my day.
https://supportforums.cisco.com/t5/wan-routing-and-switching/pppoe-not-working-on-a-csr1000v-bridge-domain/m-p/3351028#M293586
Hi Peter,
I was looking for a workaround to terminate a VPLS tunnel on the BRAS itself and could find a feature called Pseusowire Headend which is only designed for ASR9k and then came across your perfect solution which saved my day. I just want...
Hi Reza,
The reason I asked this question is that we are going to use a pair of 6807XL with SUP2T installed as VPLS hubs which are roughly going to pass 500k PPPoE sessions and so if the limitation is per the chassis we have to come up with another...
