About KenWynWilliams

KenWynWilliams · 04-11-2006

Any ideas why the daily purge done by DFM fails everytime?The error message in the dps.log file is "in\pdexec.cmd FHPurgeTask error=5" generated by the Daily Purge Schedule job.ThanksKen

KenWynWilliams · 10-04-2005

What effect will installing a NAM-2 module cause to a c6509 sup720 when heavily utilised eg capturing data from many ports/vlans.Are there any stats available for this?I ask the question because we're thinking of installing these in our data centre c...

KenWynWilliams · 04-08-2005

I'm running Ciscoworks w RME3.5 on c4006 with various versions of CatOS. Checking the Device attributes & using Config Management always fail because according to the archive status log the failure is always "failed to get device prompt". This occurs...

KenWynWilliams · 04-02-2014

Hi Paul,you need to set all non switch ports to spanning tree port fast as this is well known to cause issues with DHCP requests when a port first connects due to it being in blocking mode until spanning tree has done its stuff.regardsken

KenWynWilliams · 04-01-2014

Hi,first off remove the default gateway address as it's wrong not required and won't help. Have you confirmed the workstations have ip addresses on the same network?try pinging the workstations from the switch and check they are in the arp cache.rega...

KenWynWilliams · 03-31-2014

Hi,That's a lot of questions!I'd use 12.2(55)SE5 c3750-ipservicesk9-mz.122-55.SE5.bin which corresponds with what you'd been advised. I know this version is very stable and thoroughly tested and used by v large institutions. The Cisco upgrade planner...

KenWynWilliams · 03-31-2014

Hi, just to be clear - you want to move SVI on vlan 1 to become a secondary on vlan 2? If so you'll need to arrange some downtime as the IOS won't allow you to configure the same IP address more than once.You also need to change all the vlan 1 server...

KenWynWilliams · 04-18-2006

Yes it was the casusers group missing Read & Execute priveledges to cmd.exe in Windows.Changed the rights on cmd.exe in system32 and the problem goes away.ThanksKen

Member Since	‎08-20-2003 07:07 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	13
Total Helpful Votes Received	5

User Statistics

User Activity

DFM purge fail (LMS2.5)

Any loss of performance with NAM installed?

RME CatOS failed to get device prompt

Hi Paul,you need to set all

Hi,first off remove the

Hi,That's a lot of questions

Hi, just to be clear - you

Re: DFM purge fail (LMS2.5)