Hello, I'm having problems with ME3600X running IOS 15.2(2)S2 (mandatory to support feature of multicast in VRF). I have to disable IGMP snooping in order to get multicast working when a flow is going from a local vlan is routed toward two PIM vlans.If I have only 1 vlan in my outgoing interface list, it's working. The show ip mroute seems to be correct but the multicast traffic is not forwarded until I disable igmp snooping on the vlan containing the source. That's really a pain ! All my multicast traffic is flooded on all trunks containing the vlan of my multicast source... If someone has a workaround for this ! Thanks , Christophe 1#sh ip mroute vrf videoprotection 239.10.19.32 IP Multicast Routing Table Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,        L - Local, P - Pruned, R - RP-bit set, F - Register flag,        T - SPT-bit set, J - Join SPT, M - MSDP created entry, E - Extranet,        X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,        U - URD, I - Received Source Specific Host Report,        Z - Multicast Tunnel, z - MDT-data group sender,        Y - Joined MDT-data group, y - Sending to MDT-data group,        G - Received BGP C-Mroute, g - Sent BGP C-Mroute,        Q - Received BGP S-A Route, q - Sent BGP S-A Route,        V - RD & Vector, v - Vector Outgoing interface flags: H - Hardware switched, A - Assert winner Timers: Uptime/Expires Interface state: Interface, Next-Hop or VCD, State/Mode (*, 239.10.19.32), 00:13:50/stopped, RP 10.254.60.1, flags: SJC   Incoming interface: Null, RPF nbr 0.0.0.0   Outgoing interface list:     Vlan60, Forward/Sparse, 00:13:50/00:02:41 (10.60.2.20, 239.10.19.32), 00:13:50/00:01:36, flags: TA   Incoming interface: Vlan60, RPF nbr 0.0.0.0   Outgoing interface list:     Vlan601, Forward/Sparse, 00:13:48/00:03:28     Vlan602, Forward/Sparse, 00:13:50/00:02:30 ... View more