Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Nexus 5010 on 4.1(3)N2(1) with a GLC-T SFP (1000BaseT) in port 1/1. I've set the speed to 1000 Mbps, the transceiver is recognized but whatever we do, the port remains " down (Link not connected)". Swapping cables or SFPs does not make any ...
I want to connect my Windows 2003 R2 64-bit server to different remote networks via IPSec, the same way a remote user would log in with a Cisco VPN client. The problem is that I cannot find a 64-bit IPSec client (Cisco or 3rd party) that runs on 2003...
Hi,I want to have my MS IAS RADIUS check on the connection profile that a SSL VPN user selected: Users can only authenticate for profiles that match their group membership. But a single user can be allowed to connect to more than one connection profi...
I have a new laptop, Lenovo T400 with Vista Business ed, SP1 installed. ASDM will not run on this laptop: Every time it just dies/disappears right after I log in. I tried different versions ASDM, different ASAs. I knew from earlier experience that th...
I have a PIX that suddenly does not want to send traffic to remote users anymore. VPN connection is established as it should, but no traffic gets out, and the only thing I can find in the logging is "IKE Initiator unable to find policy". I verified t...
Hi Martijn,If this happens a lot, my guess is that it is not a DoS attack but just the box running out of resources. You can try to increase the "ip inspect max-incomplete" values to allow more half-open sessions to see if that improves performance.S...
My guess is that somehow the trunk created a loop between vlan 1 and vlan 17. When the BPDUs from vlan 1 are looped back into vlan 17, the core1 switch will show as root with a lower prio than in vlan 17 (in Cisco PVSTP the vlan id is added to the pr...
Hi John,Not completely sure what's going on here, but in the release notes for 12.4(24)T5 I see that a whole set of 881 routers is supported, but no mention of the 881W.... When I run the software advisor for the 881W it recommends 12.4(22)T...Peter
I might be wrong, but check this: http://www.cisco.com/en/US/docs/ios/ios_xe/netmgmt/configuration/guide/nm_cfg_snmp_sup_xe.html#wp1201017The command is snmp-server user username groupname [remote ip-address [udp-port port]] {v1 | v2c | v3 [encrypted...
If all the light flash on when you connect the cable, you are probably causing a loop. Check all the cables from the switches to see if there isn't already somehow a connection active between these switches. If your switches support it, consider turn...
