Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Our client is currently on an aging CUCM 6.1 system with 38 users and no current UCSS. We're quoting a BE6K solution. Is it possible to use the 25-user starter bundle and combine with the 3-1 upgrade w/ UCSS sku for the additional 13 users? ...
I've never worked with Ironport before, so I'm trying to estimate the amount of effort required to install and configure a C170 appliance. This would be a small site deployment of approximately 150 users. If I estimate 12 hours, would that be more ...
Does UCXN have an outcall feature that can be triggered for either urgent messages only, or all messages? I'm trying to find documentation on this and am coming up empy so far.Thanks
My client has MM fiber running from IDF "A" to IDF "B", then from "B" to IDF "C". For IDF B, no user connections are needed, only the MM fiber. What would the community recommend for a Cisco switch to sit in IDF B? Initial thoughts are a 2960C or ...
Just two ports needed at 1Gig. Basically the fiber runs from location A through location B to location C. We just need a switch in the location B IDF to connect A to C. No user connectivity is needed in B.Thanks!
The new Unity 5.0 was built and fully tested prior to the migration. Mailstore integration as well as integration with CUCM was completed, and we created a couple test accounts in the Unity subscriber OU. Test VM's, MWI, etc was all good.A day afte...
